Easy Installation [Click to watch the video]
The Hurricane Clamp
Thousands Have Already Been Sold!
Paintable !
Protects Your Home !
Easy to Install !
| To begin, you should measure the window opening and cut your plywood 1/4" to 1/2" shorter than your measurement. We recommend using 3/4" plywood as tested and approved for a 46/60" window. |
One time Tools Required:
Drill, 5/8 masonry/wood bit, 1/2" metal/wood bit, hammer, tape measure and pencil. |
|
Step One:
Mark your hole location 12" from the top and bottoms, and 11/16" out from your chosen plywood.
|
|
Step Two:
Drill your holes using a 5/8" wood or concrete bit, drill approx: 1-1/2" deep. If the hole is correct, the sleeve should go in halfway before tapping in w/hammer
|
|
Step Three:
Take one of the sleeves and use a hammer to tap the sleeve into the hole
|
|
Step Four:
Drill into the sleeve with a standard 1/2" metal/wood drill bit. This will insure the best fit for the clamp
Step Five:
Insert plywood into window opening, then insert one of the Hurricane Clamps into the sleeve and lock it into the plywood. |
|
|
|
© 2008 Kejo Financial Services LLC ®
|
|
